What is 2CY Gear Oil Pump? The working principle of Gear Oil Pump



2CY Gear Oil Pump is suitable for conveying various lubricating liquids, the temperature is not higher than 70℃, if high temperature is required to be 200℃, high temperature resistant materials can be used. 2CY Gear Oil Pump is not suitable for transporting corrosive, hard particles or fibers, highly volatile or low flash point liquids, such as gasoline, benzene, etc.

quality 2CY Gear Oil Pump

The Gear Oil Pump uses two gears to engage and rotate mutually, which does not require high media. The general pressure is below 6MPa, and the flow rate is relatively large. Gear Oil Pump is equipped with a pair of rotating gears in the pump body, one active and one passive. The entire working chamber in the pump is divided into two independent parts by the meshing of the two gears. A is the suction cavity and B is the discharge cavity. When Gear Oil Pump is running, the driving gear drives the driven gear to rotate. When the gear is engaged to disengaged, a partial vacuum is formed on the suction side (A), and the liquid is sucked in. The sucked liquid fills the valleys of the gears and is brought to the discharge side (B). When the gears are engaged, the liquid is squeezed out to form a high-pressure liquid and is discharged out of the pump through the pump discharge port.

Features of Gear Oil Pump
1. Compact structure, easy to use and maintain.
2. It has good self-priming, so there is no need to pour in liquid before starting the pump each time.
3. The lubrication of the Gear Oil Pump is automatically achieved by the conveyed liquid, so there is no need to add lubricating oil during daily work.

Gear Oil Pump is widely used in petroleum, chemical, shipbuilding, electric power, grain and oil, food, medical treatment, building materials, metallurgy and national defense scientific research industries. Gear Oil Pump is suitable for conveying lubricating oil without solid particles and fibers, non-corrosive, temperature not higher than 150℃, viscosity of 5~1500cst or other liquids similar to lubricating oil. Gear Oil Pump can be used in all kinds of occasions where there is solidification at room temperature and outdoor installation and process requirements in high-cold areas.