How to maintain the quality 2CY Gear Oil Pump



The quality 2CY Gear Oil Pump consists of gear, shaft, pump body, pump cover, bearing sleeve, shaft end seal and so on. quality 2CY Gear Oil Pump is suitable for conveying all kinds of lubricating liquids, the temperature is not higher than 70 degrees, if the high temperature is 200 degrees, it can be equipped with high temperature resistant materials, the viscosity is 5×10-5—1.5×10- 3m2/S.

2CY Gear Oil Pump Manufacturers china

1. Always add grease, the electric oil drum pump is running at high speed, and the grease is easy to volatilize, so the lubrication at the bearing must be kept clean, and attention should be paid to the replacement;

2.Quality 2CY Gear Oil Pump should be inspected and maintained frequently, and electric oil drum pump should be inspected and maintained frequently. The power cord must be checked: whether the internal wiring, plug, switch is in good condition, whether the insulation resistance is normal, whether the brush tail seat is loose, the commutator Good contact with the brush, whether the armature winding stage expansion stator winding has a suitable circuit phenomenon, whether the bearing and rotating parts are damaged, etc.;

3. Save each part and replace the same parts. When dismantling and inspecting the quality 2CY Gear Oil Pump, you should save each part. Special attention should be paid to the explosion-proof surface of the explosion-proof parts, so that the flame-proof surface of the explosion-proof parts can not be damaged, including the insulating gasket and sleeve. If it is damaged, it must be replaced with new and identical parts. Substitute materials that are lower than the performance of the raw materials or parts that do not conform to the original specifications must not be used. When assembling, all parts should be installed in their original positions and cannot be omitted.